Cisco Nexus 7000 Series - Show Dot1 X

show dot1x
To display the 802.1X feature status, use the show dot1x command.
show dot1x
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
Any command mode
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
You must enable the 802.1X feature by using the feature dot1x command before using this command.
This command does not require a license.
Examples
This example shows how to display the 802.1X feature status:
switch# show dot1x
Sysauthcontrol Enabled
Dot1x Protocol Version 2
Related Commands
DescriptionCommand
Enables the 802.1X feature.feature dot1x
Cisco Nexus 7000 Series Security Command Reference
760
Show Commands
show dot1x