Cisco Nexus 7000 Series - Show Cts Propagate-Status

show cts propagate-status
To display interfaces configured with SGT tagging exemption for L2 control protocols, use the show cts
propagate-status command.
show cts propagate-status [interface {ethernetslot/port| port-channel channel-number}]
Syntax Description
(Optional) Specifies that the output is limited for a
particular interface.
interface
(Optional) Specifies that the output is limited to
bindings for the Ethernet interface given.
ethernetslot/port
(Optional) Specifies that the output is limited to the
specified port-channel interface. Valid port-channel
numbers are from 1 to 4096.
port-channel channel-number
Command Default
None
Command Modes
Any configuration mode
Command History
ModificationRelease
This command was introduced.8.1(1)
Usage Guidelines
To use this command, you must enable the Cisco TrustSec feature using the feature cts command.
This command requires the Advanced Services license.
Examples
The following example displays all interfaces configured with SGT tagging exemption for L2 control protocols.
switch(config)# show cts propagate-status
Interface: Ethernet2/13
Propagate Exemption:
Protocols: CDP, LLDP, LACP, EAPoL, BPDUs
Interface: Ethernet2/27
Propagate Exemption:
Protocols: CDP, LLDP, LACP, EAPoL, BPDUs
Cisco Nexus 7000 Series Security Command Reference
742
Show Commands
show cts propagate-status