Cisco Nexus 7000 Series - Show Policy-Map Interface Control-Plane

show policy-map interface control-plane
To display packet-level statistics for all classes that are part of the applied control plane policing (CoPP)
policy, use the show policy-map interface control-plane command.
show policy-map interface control-plane {[module module-number [inst-all]] [class {class-name| violated}]|
[class {class-name| violated}] [module module-number [inst-all]]}
Syntax Description
Displays the packet-level statistics for the specific
class.
class class-name
Displays the packet-level statistics for the specific
module. The range is from 1 to 18.
module module-number
Displays classes that have violated the police rate.violated
Displays per-instance statistics.inst-all
Command Modes
Any command mode
Command History
ModificationRelease
Added the inst-all keyword.8.1(1)
This command was introduced.6.2(2)
Usage Guidelines
Use this command to display the policy values with associated class maps and drops per policy or class map.
It also displays the scale factor values when a CoPP policy is applied. When the scale factor value is the default
(1.00), it is not displayed.
The scale factor changes the CIR, BC, PIR, and BE values internally on each module, but the display
shows the configured CIR, BC, PIR, and BE values only. The actual applied value on a module is the
scale factor multiplied by the configured value.
Note
This command does not require a license.
Examples
This example shows how to monitor CoPP:
switch# show policy-map interface control-plane
Control Plane
service-policy input: copp-system-policy-default
Cisco Nexus 7000 Series Security Command Reference
846
Show Commands
show policy-map interface control-plane