Cisco Nexus 7000 Series - Feature Privilege

feature privilege
To enable the cumulative privilege of roles for command authorization on TACACS+ servers, use the feature
privilegecommand. To disable the cumulative privilege of roles, use the no form of this command.
feature privilege
no feature privilege
Syntax Description
This command has no arguments or keywords.
Command Default
Disabled
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.5.0(2)
Usage Guidelines
This command does not require a license.
When the feature privilege command is enabled, privilege roles inherit the permissions of lower level privilege
roles.
Examples
This example shows how to enable the cumulative privilege of roles:
switch# configure terminal
switch(config)# feature privilege
This example shows how to disable the cumulative privilege of roles:
switch# configure terminal
switch(config)# no feature privilege
2010 Feb 12 12:52:06 switch %FEATURE-MGR-2-FM_AUTOCKPT_IN_PROGRESS: AutoCheckpoint
system-fm-privilege's creation in progress...
switch(config)# 2010 Feb 12 12:52:06 switch %FEATURE-MGR-2-FM_AUTOCKPT_SUCCEEDED
AutoCheckpoint created successfully
Related Commands
DescriptionCommand
Enables a user to move to a higher privilege level.
enable level
Enables a secret password for a specific privilege
level.
enable secret priv-lvl
Cisco Nexus 7000 Series Security Command Reference
330
F Commands
feature privilege