show copp status
To display the control plane policing (CoPP) configuration status, use the show copp status command.
show copp status
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
Any configuration mode
Command History
ModificationRelease
This command was introduced.4.0(2)
Usage Guidelines
You can use this command only in the default virtual device context (VDC).
This command does not require a license.
Examples
This example shows how to display the CoPP configuration status information:
switch# show copp status
Last Config Operation: service-policy input copp-system-policy
Last Config Operation Timestamp: 21:57:58 UTC Jun 4 2008
Last Config Operation Status: Success
Policy-map attached to the control-plane: new-copp-policy
Cisco Nexus 7000 Series Security Command Reference
721
Show Commands
show copp status
To Next Page
Loading...
