source-interface
To assign a source interface for a specific RADIUS or TACACS+ server group, use the source-interface
command. To revert to the default, use the no form of this command.
source-interface interface
no source-interface
Syntax Description
Source interface. The supported interface types are
ethernet, loopback, and mgmt 0.
interface
Command Default
The default is the global source interface.
Command Modes
RADIUS configurationTACACS+ configuration
Command History
ModificationRelease
This command was introduced.4.1(2)
Usage Guidelines
The source-interface command to override the global source interface assigned by the ip radius
source-interface command or ip tacacs source-interface command.
You must use the feature tacacs+ command before you configure TACACS+.
This command does not require a license.
Examples
This example shows how to enter IP access list configuration mode for an IPv4 ACL named ip-acl-01:
switch# configure terminal
switch(config)# ip radius source-interface mgmt 0
switch(config-radius)# source-interface ethernet 2/1
Related Commands
DescriptionCommand
Enables the TACACS+ feature.feature tacacs+
Configures the global source interface for the
RADIUS groups configured on the Cisco NX-OS
device.
ip radius source-interface
Cisco Nexus 7000 Series Security Command Reference
661
S Commands
source-interface
To Next Page
Loading...
