Cisco Nexus 7000 Series - Cts Sxp Connection Peer

cts sxp connection peer
To configure a Security Group Tag (SGT) Exchange Protocol (SXP) peer connection for Cisco TrustSec, use
the cts sxp connection peer command. To remove the SXP connection, use the no form of this command.
cts sxp connection peer ipv4-address [sourcesource-ip-address password {default| none| required} mode
{local| peer} [[[listener| speaker] [hold-time minimum-time maximum-time]]| both [vrf vrf-name]]
no cts sxp connection peer ipv4-address {source| password} {default| none} mode {local| peer} [[[listener|
speaker] [hold-time minimum-time maximum-time| vrf vrf-name]]| both [vrf vrf-name]]
Syntax Description
IPv4 address of the peer device.
peer-ipv4-addr
(Optional) Specifies the IPv4 address of the source
device.
source src-ipv4-addr
Specifies the password option to use for the SXP
authentication.
password
Specifies that SXP should use the default SXP
password for the peer connection.
default
Specifies that SXP should not use a password.none
Specifies the password that SXP should use for this
peer connection.
required
Clear text password. The password is alphanumeric
and case-sensitive. The maximum length is 32
characters.
password
Specifies an encrypted password. The maximum
length is 32 characters.
7 encrypted password
Specifies the mode of the peer device.mode
Specifies that the peer is the speaker.speaker
Specifies that the peer is the listener.listener
(Optional) Specifies the VRF for the peer.
vrf vrf-name
Cisco Nexus 7000 Series Security Command Reference
173
C Commands
cts sxp connection peer