monitor session
To configure an access control list (ACL) capture session in order to selectively monitor traffic on an interface
or VLAN, use the monitor session command.
monitor session session type acl-capture
Syntax Description
Session ID. The range is from 0 to 48.
session
Specifies a session type.type
Creates an ACL capture session.acl-capture
Command Default
None
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.5.2(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to configure an ACL capture session:
switch# configure terminal
switch(config)# monitor session 5 type acl-capture
switch(config-acl-capture)#
Related Commands
DescriptionCommand
Enables access control list (ACL) capture on all
virtual device contexts (VDCs).
access-list capture
Configures a destination for ACL capture packets.destination interface
Displays the ACL capture session configuration.show ip-access capture session
Cisco Nexus 7000 Series Security Command Reference
509
M Commands
monitor session
To Next Page
Loading...
