aaa authentication login error-enable
To configure that the AAA authentication failure message displays on the console, use the aaa authentication
login error-enable command. To revert to the default, use the no form of this command.
aaa authentication login error-enable
no aaa authentication login error-enable
Syntax Description
This command has no arguments or keywords.
Command Default
Disabled
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
When you log in, the login is processed by rolling over to the local user database if the remote AAA servers
do not respond. In such cases, the following message is displayed on the user’s terminal—if you have enabled
the displaying of login failure messages:
Remote AAA servers unreachable; local authentication done.
Remote AAA servers unreachable; local authentication failed.
This command does not require a license.
Examples
This example shows how to enable the display of AAA authentication failure messages to the console:
switch# configure terminal
switch(config)# aaa authentication login error-enable
This example shows how to disable the display of AAA authentication failure messages to the console:
switch# configure terminal
switch(config)# no aaa authentication login error-enable
Related Commands
DescriptionCommand
Displays the status of the AAA authentication failure
message display.
show aaa authentication login error-enable
Cisco Nexus 7000 Series Security Command Reference
31
A Commands
aaa authentication login error-enable
To Next Page
Loading...
