Cisco Nexus 7000 Series - Show Ip Verify Source

show ip verify source
To display the IP-to-MAC address bindings, use the show ip verify source command.
show ip verify source [interface {ethernetslot/port| port-channel channel-number}]
Syntax Description
(Optional) Specifies that the output is limited to
IP-to-MAC address bindings for a particular interface.
interface
(Optional) Specifies that the output is limited to
bindings for the Ethernet interface given.
ethernetslot/port
(Optional) Specifies that the output is limited to
bindings for the port-channel interface given. Valid
port-channel numbers are from 1 to 4096.
port-channel channel-number
Command Default
None
Command Modes
Any command mode
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to display the IP-to-MAC address bindings:
switch# show ip verify source
switch#
Related Commands
DescriptionCommand
Creates a static IP source entry for the specified
Ethernet interface.
ip source binding
Enables IP Source Guard on an interface.ip verify source dhcp-snooping-vlan
Cisco Nexus 7000 Series Security Command Reference
807
Show Commands
show ip verify source