Cisco Nexus 7000 Series - Cts Sxp Allow Default-Route-Sgt

cts sxp allow default-route-sgt
To enable the default route for SGT bindings, use the cts sxp allow default-route-sgt command. To disable,
use the no form of this command.
cts sxp allow default-route-sgt
no cts sxp allow default-route-sgt
Syntax Description
This command has no arguments or keywords.
Command Default
Disabled
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.7.3(0)D1(1)
Usage Guidelines
To use this command, you must enable the Cisco TrustSec SXP feature using the cts sxp enable command.
Examples
This example shows how to expand the network limit:
switch# configure terminal
switch(config)# cts sxp allow default-route-sgt
This example shows how to disable the network limit:
switch# configure terminal
switch(config)# no cts sxp allow default-route-sgt
Related Commands
DescriptionCommand
Enables the Cisco TrustSec feature.feature cts
Displays the Cisco TrustSec SXP configuration
information.
show cts sxp
Cisco Nexus 7000 Series Security Command Reference
172
C Commands
cts sxp allow default-route-sgt