show running-config dhcp
To display the Dynamic Host Configuration Protocol (DHCP) snooping configuration in the running
configuration and verify other DHCP configurations on a device, use the show running-config dhcp command.
show running-config dhcp [all]
Syntax Description
(Optional) Displays configured and default
information.
all
Command Default
None
Command Modes
Any command mode
Command History
ModificationRelease
This command was introduced.4.0(1)
This command was modified. A sample output for DHCP relay
configuration on a Bridge Domain Interface (BDI) was added.
7.2(0)D1(1)
Usage Guidelines
To use this command, you must enable the DHCP snooping feature using the feature dhcp command.
This command does not require a license.
Examples
This example shows how to display the DHCP snooping configuration:
switch# show running-config dhcp
version 4.0(1)
feature dhcp
interface Ethernet2/46
ip verify source dhcp-snooping-vlan
ip arp inspection trust
ip dhcp snooping
ip arp inspection validate src-mac dst-mac ip
ip source binding 10.3.2.2 0f00.60b3.2333 vlan 13 interface Ethernet2/46
ip source binding 10.2.2.2 0060.3454.4555 vlan 100 interface Ethernet2/10
ip dhcp snooping vlan 1
ip arp inspection vlan 1
ip dhcp snooping vlan 13
ip arp inspection vlan 13
This example shows how to verify DHCP configurations on the device. DHCP relay configuration information
is also displayed in the example.
switch# show running-config dhcp
Cisco Nexus 7000 Series Security Command Reference
883
Show Commands
show running-config dhcp
To Next Page
Loading...
