show ip dhcp snooping binding
To display IP-to-MAC address bindings for all interfaces or a specific interface, use the show ip dhcp snooping
binding command. It includes static IP source entries. Static entries appear with the term “static” in the Type
column.
show ip dhcp snooping binding [IP-address][MAC-address] [interface ethernet slot/port] [vlanvlan-id]
show ip dhcp snooping binding [dynamic]
show ip dhcp snooping binding [static]
Syntax Description
(Optional) IPv4 address that the bindings shown must
include. Valid entries are in dotted-decimal format.
IP-address
(Optional) MAC address that the bindings shown
must include. Valid entries are in dotted-hexadecimal
format.
MAC-address
(Optional) Specifies the Ethernet interface that the
bindings shown must be associated with.
interface ethernetslot/port /
(Optional) Specifies a VLAN ID that the bindings
shown must be associated with. Valid VLAN IDs are
from 1 to 4096.
vlan vlan-id
(Optional) Limits the output to all dynamic IP-MAC
address bindings.
dynamic
(Optional) Limits the output to all static IP-MAC
address bindings.
static
Command Default
None
Command Modes
Any command mode
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
This command does not require a license.
Cisco Nexus 7000 Series Security Command Reference
801
Show Commands
show ip dhcp snooping binding
To Next Page
Loading...
