storm-control level
To set the suppression level for traffic storm control, use the storm-control level command. To turn off the
suppression mode or revert to the default, use the no form of this command.
storm-control {broadcast| multicast| unicast} level percentage [. fraction]
no storm-control {broadcast| multicast| unicast} level
Syntax Description
Specifies the broadcast traffic.broadcast
Specifies the multicast traffic.multicast
Specifies the unicast traffic.unicast
Percentage of the suppression level. The range is from
0 to 100 percent.
percentage
(Optional) Fraction of the suppression level. The
range is from 0 to 99.
. fraction
Command Default
All packets are passed
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
Enter the storm-control level command to enable traffic storm control on the interface, configure the traffic
storm-control level, and apply the traffic storm-control level to all traffic storm-control modes that are enabled
on the interface.
Only one suppression level is shared by all three suppression modes. For example, if you set the broadcast
level to 30 and set the multicast level to 40, both levels are enabled and set to 40.
The period (.) is required when you enter the fractional-suppression level.
The suppression level is a percentage of the total bandwidth. A threshold value of 100 percent means that no
limit is placed on traffic. A threshold value of 0 or 0.0 (fractional) percent means that all specified traffic is
blocked on a port.
Use the show interfaces counters broadcast command to display the discard count.
Cisco Nexus 7000 Series Security Command Reference
673
S Commands
storm-control level
To Next Page
Loading...
