Cisco Nexus 7000 Series - Show System Internal Udp-Relay Database

show system internal udp-relay database
To display the configuration details of the UDP relay feature, use the show system internal udp-relay
database command.
show system internal udp-relay database
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
Any command mode
Command History
ModificationRelease
This command was introduced.7.3(0)D1(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to display the details of the UDP relay feature:
switch# show system internal udp-relay database
UDP Relay enabled : Yes
Relay enabled on the following UDP Ports:
---------------------------------------------------------------
Sr No. UDP-Port Default Port?
------ --------------- ----------------------
1. 37 Yes
2. 42 Yes
3. 49 Yes
4. 53 Yes
5. 69 Yes
6. 137 Yes
7. 138 Yes
-----------------------------------------
Object Groups information:
-------------------------------------------
--------------------------------------------------------
Object-Group Name : iHello
No. of Relay Addresses : 3
1 . IP-Addr : 2.6.8.12 Netmask : 255.255.255.255
2 . IP-Addr : 9.8.7.6 Netmask : 255.255.255.255
3 . IP-Addr : 2.4.6.8 Netmask : 255.255.0.0
Associated Interfaces:
-----------------------------------
Vlan800 Subnet-broadcast enabled
---------------------------------------------------------------
Object-Group Name : iSmart
No. of Relay Addresses : 1
1 . IP-Addr : 4.5.6.7 Netmask : 255.255.0.0
Associated Interfaces:
Cisco Nexus 7000 Series Security Command Reference
917
Show Commands
show system internal udp-relay database