aaa authentication eou default group
To configure AAA authentication methods for EAP over UDP (EoU), use the aaa authentication eou default
group command. To revert to the default, use the no form of this command.
aaa authentication eou default group group-list
no aaa authentication eou default group group-list
Syntax Description
Space-separated list of RADIUS server groups that
can include the following:
•
radius for all configured RADIUS servers.
•
Any configured RADIUS server group name.
The maximum number of names in the list is eight.
group-list
Command Default
None
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
Before configuring EAPoUDP default authentication methods, you must enable EAPoUDP using the feature
eou command.
The group-list refers to a set of previously defined RADIUS servers. Use the radius-server host command
to configure the host servers. Use the aaa group server command to create a named group of servers.
Use the show aaa groups command to display the RADIUS server groups on the device.
If you specify more that one server group, the Cisco NX-OS software checks each group in the order that you
specify in the list.
This command does not require a license.
Examples
This example shows how to configure methods for EAPoUDP authentication:
switch# configure terminal
switch(config)# aaa authentication eou default group EoUGroup
Cisco Nexus 7000 Series Security Command Reference
23
A Commands
aaa authentication eou default group
To Next Page
Loading...
