Cisco Nexus 7000 Series - Eou Default

eou default
To revert to the default global or interface configuration values for Extensible Authentication Protocol over
User Datagram Protocol (EAPoUDP), use the eou default command.
eou default
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
Global configuration Interface configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
You must use the feature eou command before you configure EAPoUDP.
This command does not require a license.
Examples
This example shows how to change the global EAPoUDP configuration to the default:
switch# config t
switch(config)# eou default
This example shows how to change the EAPoUDP configuration for an interface to the default:
switch# config t
switch(config)# interface ethernet 1/1
switch(config-if)# eou default
Related Commands
DescriptionCommand
Enables EAPoUDP.feature eou
Displays EAPoUDP information.show eou
Cisco Nexus 7000 Series Security Command Reference
295
E Commands
eou default