Cisco Nexus 7000 Series - Hardware Access-List Allow Deny Ace

hardware access-list allow deny ace
To enable deny ace support for seq based feature, use the hardware access-list allow deny ace command.
To disable this feature, use the nno form of the command.
hardware access-list allow deny ace
no hardware access-list allow deny ace
Syntax Description
This command has no arguments or keywords.
Command Default
Disabled
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.6.1(3)
Usage Guidelines
This command does not require a license.
Deny ace feature is not supported on F1 module.Note
This example shows how to enable deny ace feature:
switch# configure terminal
switch(config)# hardware access-list allow deny ace
switch(config)#
This example shows how to disable deny ace feature:
switch# configure terminal
switch(config)# no hardware access-list allow deny ace
switch(config)#
Related Commands
DescriptionCommand
Configures how a supervisor module updates an I/O
module with changes to an ACL.
hardware access-list update
Cisco Nexus 7000 Series Security Command Reference
348
H Commands
hardware access-list allow deny ace