permit (IPv6)
To create an IPv6 ACL rule that permits traffic matching its conditions, use the permit command. To remove
a rule, use the no form of this command.
General Syntax
[ sequence-number ] permit protocol source destination [dscp dscp] [flow-label flow-label-value] [fragments]
[log] [time-range time-range-name] [packet-length operator packet-length [ packet-length ]]
no permit protocol source destination [dscp dscp] [flow-label flow-label-value] [fragments] [log] [time-range
time-range-name] [packet-length operator packet-length [ packet-length ]]
no sequence-number
Internet Control Message Protocol
[sequence-number| no] permit icmp source destination [icmp-message| icmp-type [ icmp-code ]] [dscp dscp]
[flow-label flow-label-value] [fragments] [log] [time-range time-range-name] [packet-length operator
packet-length [ packet-length ]]
Internet Protocol v6
[ sequence-number ] permit ipv6 source destination [dscp dscp] [flow-label flow-label-value] [fragments]
[log] [time-range time-range-name] [packet-length operator packet-length [ packet-length ]]
Stream Control Transmission Protocol
[sequence-number| no] permit sctp source [operator port [ port ]| portgroup portgroup] destination [operator
port [ port ]| portgroup portgroup] [dscp dscp] [flow-label flow-label-value] [fragments] [log] [time-range
time-range-name] [packet-length operator packet-length [ packet-length ]]
Transmission Control Protocol
[ sequence-number ] permit tcp source [operator port [ port ]| portgroup portgroup] destination [operator
port [ port ]| portgroup portgroup] [dscp dscp] [flow-label flow-label-value] [fragments] [log] [time-range
time-range-name] [ flags ] [established] [packet-length operator packet-length [ packet-length ]]
User Datagram Protocol
[sequence-number| no] permit udp source [operator port [ port ]| portgroup portgroup] destination [operator
port [ port ]| portgroup portgroup] [dscp dscp] [flow-label flow-label-value] [fragments] [log] [time-range
time-range-name] [packet-length operator packet-length [ packet-length ]]
Cisco Nexus 7000 Series Security Command Reference
556
P Commands
permit (IPv6)
To Next Page
Loading...
