ipv6 snooping attach-policy
To apply an IPv6 snooping policy to a target, use the ipv6 snooping attach-policy command in IPv6 snooping
configuration mode, or interface configuration mode. To remove a policy from a target, no form of this
command.
ipv6 snooping attach-policy policy-name
Syntax Description
User-defined name of the snooping policy. The policy
name can be a symbolic string (such as Engineering)
or an integer (such as 0).
policy-name
Command Default
An IPv6 snooping policy is not attached to a target.
Command Modes
IPv6 snooping configuration (config-ipv6-snooping)
Command History
ModificationRelease
This command was introduced.8.0(1)
Usage Guidelines
Once a policy has been identified or configured, it is applied on a target using the ipv6 snooping attach-policy
command. This command is applied on any target, which varies depending on the platform. Examples of
targets (depending on the platform used) include device ports, switchports, Layer 2 interfaces, Layer 3
interfaces, and VLANs.
Examples
The following examples shows how to apply an IPv6 snooping policy named policy1 to a target:
switch(config)# ipv6 snooping policy policy1
switch(config-ipv6-snooping)# ipv6 snooping attach-policy policy1
Cisco Nexus 7000 Series Security Command Reference
462
I Commands
ipv6 snooping attach-policy
To Next Page
Loading...
