Cisco Nexus 7000 Series - Show Cts Sap Pmk

show cts sap pmk
To display the Cisco TrustSec Security Association Protocol (SAP) pairwise master key (PMK) configuration,
use the show cts sap pmk command.
show cts sap pmk {all| interface ethernet slot/port}
Syntax Description
Displays the hexadecimal value of the configured
PMK for all interfaces.
all
Displays the hexadecimal value of the configured
PMK for the specific Ethernet interface.
interface ethernet slot/port
Command Default
None
Command Modes
Any configuration mode
Command History
ModificationRelease
This command was introduced.6.2(2)
Usage Guidelines
To use this command, you must enable the Cisco TrustSec feature using the feature cts command.
This command does not require a license.
Examples
This example shows how to display the Cisco TrustSec SAP PMK configuration:
switch# show cts sap pmk interface ethernet 2/2
Related Commands
DescriptionCommand
Enables the Cisco TrustSec feature.feature cts
Configures the Cisco TrustSec SAP PMK.sap pmk
Cisco Nexus 7000 Series Security Command Reference
754
Show Commands
show cts sap pmk