Cisco Nexus 7000 Series - Show Ip Arp Inspection Interface

show ip arp inspection interface
To display the trust state and the ARP packet rate for the specified interface, use the show ip arp inspection
interface command.
Syntax Description
show ip arp inspection interfaceethernet slot/port| port-channel channel-number
(Optional) Specifies that the output is for an Ethernet
interface.
ethernet slot /port
(Optional) Specifies that the output is for a
port-channel interface. Valid port-channel numbers
are from 1 to 4096.
port-channel channel-number
Command Default
None
Command Modes
Any command mode
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to display the trust state and the ARP packet rate for a trusted interface:
switch# show ip arp inspection interface ethernet 2/1
Interface Trust State Rate (pps) Burst Interval
------------- ----------- ---------- --------------
Ethernet2/46 Trusted 15 5
switch#
Related Commands
DescriptionCommand
Enables Dynamic ARP Inspection (DAI) for a
specified list of VLANs.
ip arp inspection vlan
Displays the DAI configuration status.show ip arp inspection
Cisco Nexus 7000 Series Security Command Reference
784
Show Commands
show ip arp inspection interface