radius-server deadtime
To configure the dead-time interval for all RADIUS servers on a Cisco NX-OS device, use the radius-server
deadtime command. To revert to the default, use the no form of this command.
radius-server deadtime minutes
no radius-server deadtime minutes
Syntax Description
Number of minutes for the dead-time interval. The
range is from 1 to 1440 minutes.
minutes
Command Default
0 minutes
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
The dead-time interval is the number of minutes before the Cisco NX-OS device checks a RADIUS server
that was previously unresponsive.
The default idle timer value is 0 minutes. When the idle time interval is 0 minutes, periodic RADIUS
server monitoring is not performed.
Note
The command does not require a license.
Examples
This example shows how to configure the global dead-time interval for all RADIUS servers to perform periodic
monitoring:
switch# configure terminal
switch(config)# radius-server deadtime 5
This example shows how to revert to the default for the global dead-time interval for all RADIUS servers and
disable periodic server monitoring:
switch# configure terminal
switch(config)# no radius-server deadtime 5
Cisco Nexus 7000 Series Security Command Reference
601
R Commands
radius-server deadtime
To Next Page
Loading...
