Cisco Nexus 7000 Series - Hardware Rate-Limiter

hardware rate-limiter
To configure rate limits in packets per second on supervisor-bound traffic, use the hardware rate-limiter
command. To revert to the default, use the no form of this command.
hardware rate-limiter {access-list-log {packets| disable} [module module [port start end]]| copy {packets|
disable} [module modulemodule [port start end]]| f1 {rl-1 {packets| disable} [module module [port start
end]]| rl-2 {packets| disable} [module module [port start end]]| rl-3 {packets| disable} [module module[port
start end]]| rl-4 {packets| disable} [module module [port start end]]| rl-5 {packets| disable} [module module
[port start end]]}| layer-2 {l2pt {packets| disable} [module module [port start end]]| mcast-snooping
{packets| disable} [module module [port start end]]| port-security {packets| disable} [module module [port
start end]]| storm-control {packets| disable} [module module [port start end]]| vpc-low {packets| disable}
[module module [port start end]]}| layer-3 {control {packets| disable} [module module [port start end]]|
glean {packets| disable} [module module [port start end]]| glean-fast {packets| disable} [module module
[port start end]]| mtu {packets| disable} [module module [port start end]]| multicast {packets| disable}
[module module [port start end]]| ttl {packets| disable} [module module [port start end]]}| receive {packets|
disable} [module module [port start end]]| || [portgroup-multiplier multiplier module module]}
nohardware rate-limiter {access-list-log {packets| disable} [module module [port start end]]| copy {packets|
disable} [module modulemodule [port start end]]| f1 {rl-1 {packets| disable} [module module [port start
end]]| rl-2 {packets| disable} [module module [port start end]]| rl-3 {packets| disable} [module module[port
start end]]| rl-4 {packets| disable} [module module [port start end]]| rl-5 {packets| disable} [module module
[port start end]]}| layer-2 {l2pt {packets| disable} [module module [port start end]]| mcast-snooping
{packets| disable} [module module [port start end]]| port-security {packets| disable} [module module [port
start end]]| storm-control {packets| disable} [module module [port start end]]| vpc-low {packets| disable}
[module module [port start end]]}| layer-3 {control {packets| disable} [module module [port start end]]|
glean {packets| disable} [module module [port start end]]| glean-fast {packets| disable} [module module
[port start end]]| mtu {packets| disable} [module module [port start end]]| multicast {packets| disable}
[module module [port start end]]| ttl {packets| disable} [module module [port start end]]}| receive {packets|
disable} [module module [port start end]]| || [portgroup-multiplier multiplier module module]}
Syntax Description
Specifies packets copied to the supervisor module for
access list logging. The default rate is 100 packets
per second.
access-list-log
Number of packets per second. The range is from 1
to 33554431.
packets
Disables the rate limiter.disable
(Optional) Specifies a module number. The range is
from 1 to 18.
module module
(Optional) Specifies a port start index. The range is
from 1 to 32. You specify the start port and and end
port with a space in between them.
port start end
Cisco Nexus 7000 Series Security Command Reference
356
H Commands
hardware rate-limiter