Cisco Nexus 7000 Series - Page 383

Specifies data and control packets copied to the
supervisor module. The default rate is 30000 packets
per second.
copy
Specifies the control packets from the F1 modules to
the supervisor.
f1
Specifies the F1 rate-limiter 1.rl-1
Specifies the F1 rate-limiter 2.rl-2
Specifies the F1 rate-limiter 3.rl-3
Specifies the F1 rate-limiter 4.rl-4
Specifies the F1 rate-limiter 5.rl-5
Specifies Layer 2 packet rate limits.layer-2
Specifies Layer 2 Tunnel Protocol (L2TP) packets.
The default rate is 4096 packets per second.
l2pt
Specifies Layer 2 multicast-snooping packets. The
default rate is 10000 packets per second.
mcast-snooping
Specifies port security packets. The default is
disabled.
port-security
Specifies broadcast, multicast, and unknown unicast
storm-control packets. The default is disabled.
storm-control
Specifies Layer 2 control packets over the virtual port
channel (vPC) low queue. It synchronizes
control-plane communication between vPC peer
switches that are of a lower priority and protects the
control plane when a vPC peer switch misbehaves or
excessive traffic occurs between the two. The default
rate is 4000 packets per second.
vpc-low
Specifies Layer 3 packet rate limits.layer-3
Specifies Layer-3 control packets. The default rate is
10000 packets per second.
control
Specifies Layer-3 glean packets. The default rate is
100 packets per second.
glean
Specifies Layer 3 glean fast-path packets. The default
rate is 100 packets per second.
glean-fast
Cisco Nexus 7000 Series Security Command Reference
357
H Commands
hardware rate-limiter