Specifies Layer-3 maximum transmission unit (MTU)
failure redirected packets. The default rate is 500
packets per second.
mtu
Specifies Layer-3 multicast packets per second.multicast
Specifies Layer-3 failed time-to-live redirected
packets. The default rate is 500 packets per second.
ttl
Specifies packets redirected to the supervisor module.
The default rate is 30000 packets per second.
receive
Specifies the multiplier value. The range is from 0.10
to 3.00. The default value is 1.00.
This applies to F2, F2e, and F3
cards.
Note
portgroup-multiplier multiplier
Command Default
See the Syntax Description for the default rate limits.
Default rate limits for the F1 Series modules:
RL-1: 4500 packets per second
RL-2: 1000 packets per second
RL-3: 1000 packets per second
RL-4: 100 packets per second
RL-5: 1500 packets per second
Command Modes
Global configuration
Command History
ModificationRelease
Added the portgroup-multiplier keyword and the multiplier parameter.
6.2(12)
Added the glean-fast keyword.6.2(2)
Added the f1, rl-1, rl-2, rl-3, rl-4, and rl-5 keywords.
Also, added the following keywords:
module, disable, and port.
5.1(1)
Added the l2pt keyword.5.0(2)
This command was introduced to replace the platform rate-limit command.4.1(2)
Cisco Nexus 7000 Series Security Command Reference
358
H Commands
hardware rate-limiter
To Next Page
Loading...
