show cts l3 mapping
To display the Layer 3 Cisco TrustSec mapping configuration for the device, use the show cts l3 mapping
command.
show cts l3 mapping
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
Any configuration mode
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
To use this command, you must enable the Cisco TrustSec feature using the feature cts command.
This command requires the Advanced Services license.
Examples
This example shows how to display the Layer 3 Cisco TrustSec mapping for the device:
switch# show cts l3 mapping
Related Commands
DescriptionCommand
Enables the Cisco TrustSec feature.feature cts
Cisco Nexus 7000 Series Security Command Reference
740
Show Commands
show cts l3 mapping
To Next Page
Loading...
