show ldap-server
To display the Lightweight Directory Access Protocol (LDAP) server configuration, use the show ldap-server
command.
show ldap-server
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
Any command mode
Command History
ModificationRelease
This command was introduced.5.0(2)
Usage Guidelines
You must use the feature ldap command before you can display LDAP information.
This command does not require a license.
Examples
This example shows how to display the LDAP server configuration:
switch# show ldap-server
timeout : 5
port : 389
deadtime : 0
total number of servers : 0
Related Commands
DescriptionCommand
Enables LDAP.feature ldap
Specifies the IPv4 or IPv6 address or hostname for
an LDAP server.
ldap-server host
Cisco Nexus 7000 Series Security Command Reference
832
Show Commands
show ldap-server
To Next Page
Loading...
