dot1x radius-accounting
To enable RADIUS accounting for 802.1X, use the dot1x radius-accounting command. To revert to the
default, use the no form of this command.
dot1x radius-accounting
no dot1x radius-accounting
Syntax Description
This command has no arguments or keywords.
Command Default
Disabled
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
You must use the feature dot1x command before you configure 802.1X.
This command does not require a license.
Examples
This example shows how to enable RADIUS accounting for 802.1X authentication:
switch# configure terminal
switch(config)# dot1x radius-accounting
This example shows how to disable RADIUS accounting for 802.1X authentication:
switch# configure terminal
switch(config)# no dot1x radius-accounting
Related Commands
DescriptionCommand
Enables the 802.1X feature.feature dot1x
Displays all 802.1X information in the running
configuration.
show running-config dot1x all
Cisco Nexus 7000 Series Security Command Reference
201
D Commands
dot1x radius-accounting
To Next Page
Loading...
