Cisco Nexus 7000 Series - Show Vlan Filter

show vlan filter
To display information about instances of the vlan filter command, including the VLAN access-map and the
VLAN IDs affected by the command, use the show vlan filter command.
show vlan filter [access-map map-name| vlan vlan-ID]
Syntax Description
(Optional) Limits the output to VLANs that the
specified access map is applied to.
access-map map-name
(Optional) Limits the output to access maps that are
applied to the specified VLAN only. Valid VLAN
IDs are from 1 to 4096.
vlanvlan-ID
Command Default
The device shows all instances of VLAN access maps applied to a VLAN, unless you use the access-map
keyword and specify an access map, or you use the vlan keyword and specify a VLAN ID.
Command Modes
Any command mode
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to display all VLAN access map information on a device that has only one VLAN
access map applied (austin-vlan-map) to VLANs 20 through 35 and 42 through 80:
switch# show vlan filter
vlan map austin-vlan-map:
Configured on VLANs: 20-35,42-80
Related Commands
DescriptionCommand
Specifies an action for traffic filtering in a VLAN
access map.
action
Specifies an ACL for traffic filtering in a VLAN
access map.
match
Cisco Nexus 7000 Series Security Command Reference
935
Show Commands
show vlan filter