eou port
To configure the User Datagram Protocol (UDP) port number for Extensible Authentication Protocol over
UDP (EAPoUDP), use the eou port command. To revert to the default, use the no form of this command.
eou port udp-port
no eou port
Syntax Description
UDP port number. The range is from 1 to 65535.
udp-port
Command Default
21862 (0x5566)
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
You must use the feature eou command before you configure EAPoUDP.
This command does not require a license.
Examples
This example shows how to change the UDP port number for EAPoUDP:
switch# config t
switch(config)# eou port 21856
This example shows how to revert to the default UDP port number for EAPoUDP:
switch# config t
switch(config)# no eou port
Related Commands
DescriptionCommand
Enables EAPoUDP.feature eou
Displays EAPoUDP information.show eou
Cisco Nexus 7000 Series Security Command Reference
302
E Commands
eou port
To Next Page
Loading...
