interface policy deny
To enter interface policy configuration mode for a user role, use the interface policy deny command. To
revert to the default interface policy for a user role, use the no form of this command.
interface policy deny
no interface policy deny
Syntax Description
This command has no arguments or keywords.
Command Default
All interfaces
Command Modes
User role configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
This command denies all interfaces to the user role except for those that you allow using the permit interface
command in user role interface policy configuration mode.
This command does not require a license.
Examples
This example shows how to enter user role interface policy configuration mode for a user role:
switch# configure terminal
switch(config)# role name MyRole
switch(config-role)# interface policy deny
switch(config-role-interface)#
This example shows how to revert to the default interface policy for a user role:
switch# configure terminal
switch(config)# role name MyRole
switch(config-role)# no interface policy deny
Related Commands
DescriptionCommand
Permits interfaces in a role interface policy.permit interface
Creates or specifies a user role and enters user role
configuration mode.
role name
Displays user role information.show role
Cisco Nexus 7000 Series Security Command Reference
371
I Commands
interface policy deny
To Next Page
Loading...
