Cisco Nexus 7000 Series - Device

device
To add a supplicant device to the Extensible Authentication Protocol over User Datagram Protocol (EAPoUDP)
identity profile exception list, use the device command. To remove a supplicant device, use the no form of
this command.
device {authenticate| not-authenticate} {ip-address ipv4-address [ subnet-mask ]| mac-address mac-address
[ mac-address-mask ]} policy policy-name
no device {authenticate| not-authenticate} {ip-address ipv4-address [ subnet-mask ]| mac-address
mac-address [ mac-address-mask ]} policy policy-name
Syntax Description
Specifies to allow authentication of the device using
the policy.
authenticate
Specifies to not allow authentication of the device
using the policy.
not-authenticate
Specifies the IPv4 address for the supplicant device
in the A.B.C.D format.
ip-address ipv4-address
(Optional) IPv4 subnet mask for the IPv4 address.
subnet-mask
Specifies the MAC address for the supplicant device
in the XXXX.XXXX.XXXX format.
mac-address mac-address
(Optional) Mask for the MAC address.
mac-address-mask
Specifies the policy to use for the supplicant device.
policy policy-name
Command Default
None
Command Modes
Identity policy configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
This command does not require a license.
Cisco Nexus 7000 Series Security Command Reference
270
D Commands
device