show vlan access-list
To display the contents of the IPv4 access control list (ACL), IPv6 ACL, or MAC ACL associated with a
specific VLAN access map, use the show vlan access-list command.
show vlan access-list access-list-name
Syntax Description
Name of the VLAN access map, which can be up to
64 alphanumeric, case-sensitive characters.
access-list-name
Command Default
None
Command Modes
Any command mode
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to use the show vlan access-list command to display the contents of the ACL that
the VLAN access map named vacl-01 is configured to use:
switch# show vlan access-list vacl-01
IP access list ipv4acl
5 deny ip 10.1.1.1/32 any
10 permit ip any any
Related Commands
DescriptionCommand
Configures an VLAN access map.vlan access-map
Displays all ACLs or a specific ACL.show access-lists
Displays all IPv4 ACLs or a specific IPv4 ACL.show ip access-lists
Displays all IPv6 ACLs or a specific IPv6 ACL.show ipv6 access-lists
Displays all MAC ACLs or a specific MAC ACL.show mac access-lists
Cisco Nexus 7000 Series Security Command Reference
931
Show Commands
show vlan access-list
To Next Page
Loading...
