Cisco Nexus 7000 Series - Cts Sxp Enable

cts sxp enable
To enable the Security Group Tag (SGT) Exchange Protocol (SXP) peer on a device, use the cts sxp enable
command. To revert to the default, use the no form of this command.
cts sxp enable
no cts sxp enable
Syntax Description
This command has no arguments or keywords.
Command Default
Disabled
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
To use this command, you must enable the Cisco TrustSec feature using the feature cts command.
This command requires the Advanced Services license.
Examples
This example shows how to enable SXP:
switch# configure terminal
switch(config)# cts sxp enable
This example shows how to disable SXP:
switch# configure terminal
switch(config)# no cts sxp enable
Related Commands
DescriptionCommand
Enables the Cisco TrustSec feature.feature cts
Displays the Cisco TrustSec SXP configuration
information.
show cts sxp
Cisco Nexus 7000 Series Security Command Reference
179
C Commands
cts sxp enable