Cisco Nexus 7000 Series - Ipv6 Dhcp-Ldra Attach Policy (Interface)

ipv6 dhcp-ldra attach policy (interface)
To enable the Lightweight DHCPv6 Relay Agent (LDRA) feature on an interface, use the ipv6 dhcp-ldra
command.
ipv6 dhcp-ldra attach-policy {client-facing-trusted| client-facing-untrusted| client-facing-disable|
server-facing}
no ipv6 dhcp-ldra attach-policy {client-facing-trusted| client-facing-untrusted| client-facing-disable|
server-facing}
Syntax Description
Specifies client-facing interfaces or ports as trusted.client-facing-trusted
Specifies client-facing interfaces or ports as untrusted.client-facing-untrusted
Disables LDRA functionality on an interface or port.client-facing-disable
Specifies an interface or port as server facing.server-facing
Command Default
Disabled
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.7.3(0)D1(1)
Usage Guidelines
To use this command, you must enable the LDRA feature by using the ipv6 dhcp-ldra command.
Examples
This example shows how to enable the LDRA feature on the specified interface:
switch(config)# ipv6 dhcp-ldra
switch(config)# interface ethernet 0/0
switch(config-if)# switchport
switch(config-if)# ipv6 dhcp-ldra attach-policy client-facing-trusted
This example shows how to disable the LDRA feature on the specified interface:
switch(config-if)# no ipv6 dhcp-ldra attach-policy client-facing-trusted
Related Commands
DescriptionCommand
Enables the LDRA feature.ipv6 dhcp-ldra
Cisco Nexus 7000 Series Security Command Reference
443
I Commands
ipv6 dhcp-ldra attach policy (interface)