crypto ca test verify
To verify a certificate file, use the crypto ca test verify command.
crypto ca test verify certificate-file
Syntax Description
Certificate filename in the form bootflash:filename
. The filename is case sensitive.
certificate-file
Command Default
None
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.4.1(2)
Usage Guidelines
Use this command to verify the specified certificate in the PEM format by using the trusted CAs configured
and by consulting the certificate revocation list (CRL), if needed, as indicated by the revocation checking
configuration.
This command does not require a license.
Examples
This example shows how to verify a certificate file:
switch(config)# crypto ca test verify bootflash:id1.pem
verify status oode:0
verify error msg:
The verify status code value of 0 indicates that the verification is successful.Note
Related Commands
DescriptionCommand
Displays configured trustpoint certificates.show crypto ca certificates
Cisco Nexus 7000 Series Security Command Reference
136
C Commands
crypto ca test verify
To Next Page
Loading...
