Cisco Nexus 7000 Series - Ip Verify Source Dhcp-Snooping-Vlan

ip verify source dhcp-snooping-vlan
To enable IP Source Guard on a Layer 2 Ethernet interface, use the ip verify source dhcp-snooping-vlan
command. To disable IP Source Guard on an interface, use the no form of this command.
ip verify source dhcp-snooping-vlan
no ip verify source dhcp-snooping-vlan
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
By default, IP Source Guard is not enabled on any interface.
This command does not require a license.
Examples
This example shows how to enable IP Source Guard on an interface:
switch# configure terminal
switch(config)# interface ethernet 2/1
switch(config-if)# ip verify source dhcp-snooping-vlan
switch(config-if)#
Related Commands
DescriptionCommand
Creates a static IP source entry for the specified
Ethernet interface.
ip source binding
Displays IP-to-MAC address bindings.show ip verify source
Cisco Nexus 7000 Series Security Command Reference
429
I Commands
ip verify source dhcp-snooping-vlan