show vlan access-map
To display all VLAN access maps or a VLAN access map, use the show vlan access-map command.
show vlan access-map map-name
Syntax Description
VLAN access map, which can be up to 64
alphanumeric, case-sensitive characters.
map-name
Command Default
None
Command Modes
Any command mode
Command History
ModificationRelease
Command output is sorted alphabetically by the ACL names.4.2(1)
This command was introduced.4.0(1)
Usage Guidelines
The device shows all VLAN access maps, unless you use the map-name argument to specify an access map.
If you do not specify an access-map name, the device lists VLAN access maps alphabetically by access-map
name.
For each VLAN access map displayed, the device shows the access-map name, the ACL specified by the
match command, and the action specified by the action command.
Use the show vlan filter command to see which VLANs have a VLAN access map applied to them.
This command does not require a license.
Examples
This example shows how to remove dynamically learned, secure MAC addresses from the Ethernet 2/1
interface:
switch# show vlan access-map
Vlan access-map austin-vlan-map
match ip: austin-corp-acl
action: forward
Cisco Nexus 7000 Series Security Command Reference
933
Show Commands
show vlan access-map
To Next Page
Loading...
