Cisco Nexus 7000 Series - Show Cts Capability Interface

show cts capability interface
To display the Cisco TrustSec capability of all interfaces or a specific Ethernet interface, use the show cts
capability interface command.
show cts capability interface {all| ethernet}
Syntax Description
Displays the Cisco TrustSec capability of all
interfaces.
all
Displays the Cisco TrustSec capability of the specific
interface.
ethernet slot/port
Command Default
None
Command Modes
Any configuration mode
Command History
ModificationRelease
This command was introduced.6.2(2)
Usage Guidelines
To use this command, you must enable the Cisco TrustSec feature using the feature cts command.
This command does not require a license.
Examples
This example shows how to display the Cisco TrustSec capability of all interfaces:
switch# show cts capability interface all
CTS capability information for interface(s)
--------- --- ------ ---------------------------------------
Interface SGT MacSec Comments
--------- --- ------ ---------------------------------------
Eth6/1 Yes Yes cts dot1x and manual configs allowed
Eth8/1 Yes Yes cts dot1x and manual configs allowed
Eth8/17 Yes Yes cts dot1x and manual configs allowed
Eth8/33 Yes Yes cts dot1x and manual configs allowed
Eth6/2 Yes Yes cts dot1x and manual configs allowed
Eth8/2 Yes Yes cts dot1x and manual configs allowed
Eth8/18 Yes Yes cts dot1x and manual configs allowed
Eth8/34 Yes Yes cts dot1x and manual configs allowed
Eth6/3 Yes Yes cts dot1x and manual configs allowed
Eth8/3 Yes Yes cts dot1x and manual configs allowed
Eth8/19 Yes Yes cts dot1x and manual configs allowed
Eth8/35 Yes Yes cts dot1x and manual configs allowed
Eth6/4 Yes Yes cts dot1x and manual configs allowed
Eth8/4 Yes Yes cts dot1x and manual configs allowed
Cisco Nexus 7000 Series Security Command Reference
733
Show Commands
show cts capability interface