Cisco Nexus 7000 Series - Show Ip Udp Relay

show ip udp relay
To display the configuration details of the UDP relay feature, use the show ip udp relay command.
show ip udp relay [interface [ethernet slot/port-number| port-channel port-channel-number]| object-group
object-group-name]
Syntax Description
Specifies the slot and port number.
slot/port-number
Specifies the port channel number.
port-channel-number
Specifies the name of the object group.
object-grp-name
Command Default
None
Command Modes
Any command mode
Command History
ModificationRelease
This command was introduced.7.3(0)D1(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to display the details of the UDP relay feature:
switch# show ip udp relay
UDP relay service is enabled
UDP relay on default UDP ports:
Default UDP Ports Status
--------------------------- -------------
Time service (port 37 ) enabled
IEN-116 Name Service (port 42 ) enabled
TACACS service (port 49 ) enabled
Domain Naming System (port 53 ) enabled
Trivial File Transfer Protocol (port 69 ) enabled
NetBIOS Name Server (port 137) enabled
NetBIOS Datagram Server (port 138) enabled
UDP relay is enabled on the following non-default UDP ports:
-----------------------------------------------------------------
Object-group and Subnet-broadcast configurations:
Interface Subnet-broadcast Object-group
---------- ---------------- ------------
Vlan700 disabled iSmart
Vlan800 enabled iHello
Cisco Nexus 7000 Series Security Command Reference
805
Show Commands
show ip udp relay