Cisco Nexus 7000 Series - Show Ipv6 Dhcp Relay

show ipv6 dhcp relay
To display the DHCPv6 relay global or interface-level configuration, including DHCPv6 server addresses
configured on interfaces, use the show ipv6 dhcp relay command.
show ipv6 dhcp relay [interface interface]
Syntax Description
(Optional) Displays the DHCPv6 relay address of the
interface. The supported interface types are ethernet,
port-channel, and VLAN.
interfaceinterface
Command Default
None
Command Modes
Any command mode
Command History
ModificationRelease
This command was introduced.6.2(2)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to display the globally configured DHCPv6 relay status and DHCPv6 server addresses:
switch# show ipv6 dhcp relay
DHCPv6 relay service : Enabled
Insertion of VPN options : Disabled
Insertion of CISCO options : Disabled
DHCPv6 Relay is configured on the following interfaces:
Interface Relay Address VRF Name
------------- ------------- --------
Ethernet1/4 red
Related Commands
DescriptionCommand
Enables the DHCPv6 relay agent.ipv6 dhcp relay
Displays statistics relating to DHCPv6.show ipv6 dhcp relay statistics
Cisco Nexus 7000 Series Security Command Reference
812
Show Commands
show ipv6 dhcp relay