dot1x timeout supp-timeout
To configure the 802.1X supplicant timeout for an interface, use the dot1x timeout supp-timeout command.
To revert to the default, use the no form of this command.
dot1x timeout supp-timeout seconds
no dot1x timeout supp-timeout
Syntax Description
Number of seconds for the 802.1X supplicant timeout.
The range is from 1 to 65535.
seconds
Command Default
30 seconds
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
The 802.1X supplicant timeout for an interface is the number of seconds that the Cisco NX-OS device waits
for the supplicant to respond to an EAP request frame before the Cisco NX-OS device retransmits the frame.
You must use the feature dot1x command before you configure 802.1X.
You should change the default value only to adjust for unusual circumstances, such as unreliable links or
specific behavioral problems with certain supplicants and authentication servers.
Note
This command does not require a license.
Examples
This example shows how to configure the 802.1X server timeout interval on an interface:
switch# configure terminal
switch(config)# interface ethernet 2/1
switch(config-if)# dot1x timeout supp-timeout 45
This example shows how to revert to the default 802.1X server timeout interval on an interface:
switch# configure terminal
switch(config)# interface ethernet 2/1
switch(config-if)# no dot1x timeout supp-timeout
Cisco Nexus 7000 Series Security Command Reference
214
D Commands
dot1x timeout supp-timeout
To Next Page
Loading...
