Cisco Nexus 7000 Series - Show Cts Sxp Connection

show cts sxp connection
To display the Cisco TrustSec Security Group Tag (SGT) Exchange Protocol (SXP) connections information,
use the show cts sxp connection command.
show cts sxp connection
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
Any configuration mode
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
To use this command, you must enable the Cisco TrustSec feature using the feature cts command.
This command requires the Advanced Services license.
Examples
This example shows how to display the Cisco TrustSec Security Group Tag (SGT) Exchange Protocol (SXP)
connections information:
switch# show cts sxp connection
PEER_IP_ADDR VRF PEER_SXP_MODE SELF_SXP_MODE CONNECTION STATE VERSION
30.1.1.3 default listener speaker connected 3
Related Commands
DescriptionCommand
Enables the Cisco TrustSec feature.feature cts
Cisco Nexus 7000 Series Security Command Reference
758
Show Commands
show cts sxp connection