EasyManua.ls Logo

Cisco Nexus 7000 Series - Page 783

Cisco Nexus 7000 Series
1018 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Set up : Peer
Conn status : On
Connection inst# : 1
TCP conn fd : 2
TCP conn password: not set (using default SXP password)
Duration since last state change: 0:00:05:49 (dd:hr:mm:sec)
Total num of SXP Connections = 2
Related Commands
DescriptionCommand
Enters the Cisco TrustSec SXP peer IP address and
specifies if a password is used for the peer connection
cts sxp connection peer
Configures the Cisco TrustSec SXP default password.cts sxp default password
Configures the Cisco TrustSec SXP source IPv4
address.
cts sxp default source-ip
Enables Cisco TrustSec SXP on a device.cts sxp enable
Enables logging for IP-to-SGT binding changes.cts sxp log
Changes the Cisco TrustSec SXP reconciliation
period.
cts sxp reconciliation
Changes the Cisco TrustSec SXP retry period timer.cts sxp retry
Cisco Nexus 7000 Series Security Command Reference
757
Show Commands
show cts sxp

Table of Contents

Other manuals for Cisco Nexus 7000 Series

Related product manuals