show cts l3 interface
To display the Layer 3 Cisco TrustSec configuration on the interfaces, use the show cts l3 interface command.
show cts l3 interface
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
Any configuration mode
Command History
ModificationRelease
This command was introduced.4.0(1)
Usage Guidelines
To use this command, you must enable the Cisco TrustSec feature using the feature cts command.
This command requires the Advanced Services license.
Examples
This example shows how to display the Layer 3 Cisco TrustSec configuration for the interfaces:
switch# show cts l3 interface
Related Commands
DescriptionCommand
Enables the Cisco TrustSec feature.feature cts
Cisco Nexus 7000 Series Security Command Reference
739
Show Commands
show cts l3 interface
To Next Page
Loading...
