Cisco Nexus 7000 Series - Show Mac Access-Lists

show mac access-lists
To display all MAC access control lists (ACLs) or a specific MAC ACL, use the show mac access-lists
command.
show mac access-lists [ access-list-name ] [expanded| summary]
Syntax Description
(Optional) Name of a MAC ACL, which can be up
to 64 alphanumeric, case-sensitive characters.
access-list-name
(Optional) Specifies that the contents of object groups
show rather than the names of object groups only.
expanded
(Optional) Specifies that the command displays
information about the ACL rather than the ACL
configuration. For more information, see the “Usage
Guidelines” section.
summary
Command Default
None
Command Modes
Any command mode
Command History
ModificationRelease
Command output is sorted alphabetically by the ACL names.4.2(1)
This command was introduced.4.0(1)
Usage Guidelines
The device shows all MAC ACLs, unless you use the access-list-name argument to specify an ACL.
If you do not specify an ACL name, the device lists ACLs alphabetically by the ACL names.
The expanded keyword allows you to display the details of object groups used in an ACL rather than only
the name of the object groups. For more information about object groups, see the object-group ip address,
object-group ipv6 address, and object-group ip port commands.
The summary keyword allows you to display information about the ACL rather than the ACL configuration.
The information displayed includes the following:
•
Whether per-entry statistics are configured for the ACL.
•
The number of rules in the ACL configuration. This number does not reflect how many entries that the
ACL contains when the device applies it to an interface. If a rule in the ACL uses an object group, the
number of entries in the ACL when it is applied may be much greater than the number of rules.
Cisco Nexus 7000 Series Security Command Reference
836
Show Commands
show mac access-lists