Cisco Nexus 7000 Series - Feature Ldap

feature ldap
To enable Lightweight Directory Access Protocol (LDAP), use the feature ldap command. To disable LDAP,
use the no form of this command.
feature ldap
no feature ldap
Syntax Description
This command has no arguments or keywords.
Command Default
Disabled
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.5.0(2)
Usage Guidelines
You must use the feature ldap command before you configure LDAP.
When you disable LDAP, the Cisco NX-OS software removes the LDAP configuration.Note
This command does not require a license.
Examples
This example shows how to enable LDAP:
switch# configure terminal
switch(config)# feature ldap
This example shows how to disable LDAP:
switch# configure terminal
switch(config)# no feature ldap
Related Commands
DescriptionCommand
Displays the LDAP configuration in the running
configuration.
show running-config ldap
Displays the LDAP configuration in the startup
configuration.
show startup-config ldap
Cisco Nexus 7000 Series Security Command Reference
323
F Commands
feature ldap