show ipv6 nd raguard policy
To display a router advertisements (RAs) guard policy on all interfaces configured with the RA guard feature,
use the show ipv6 nd raguard policy command.
show ipv6 nd raguard policy [policy-name]
Syntax Description
(Optional) RA guard policy name.
policy-name
Command Modes
Any command mode
Command History
ModificationRelease
This command was introduced.8.0(1)
Usage Guidelines
The show ipv6 nd raguard policy command displays the options configured for the policy on all interfaces
configured with the RA guard feature.
Examples
The following example shows the policy configuration for a policy named raguard1 and all the interfaces
where the policy is applied:
switch# show ipv6 nd raguard policy interface raguard1
Policy raguard1 configuration:
device-role host
Policy applied on the following interfaces:
Et0/0 vlan all
Et1/0 vlan all
The table below describes the significant fields shown in the display.
Table 2: show ipv6 nd raguard policy Field Descriptions
DescriptionField
Configuration of the specified policy.Policy raguard1 configuration:
The role of the device attached to the port. This device
configuration is that of host.
device-role host
The specified interface on which the RA guard feature
is configured.
Policy applied on the following interfaces:
Cisco Nexus 7000 Series Security Command Reference
818
Show Commands
show ipv6 nd raguard policy
To Next Page
Loading...
