Cisco Nexus 7000 Series - Resequence

resequence
To reassign sequence numbers to all rules in an access control list (ACL) or a time range, use the resequence
command.
resequence access-list-type access-list access-list-name starting-sequence-number increment
resequence time-range time-range-name starting-sequence-number increment
Syntax Description
Type of the ACL. Valid values for this argument are
the following keywords:
•
arp
•
ip
•
ipv6
•
mac
access-list-type
Specifies the name of the ACL, which can be up to
64 alphanumeric, case-sensitive characters.
access-list access-list-name
Specifies the name of the time range, which can be
up to 64 alphanumeric, case-sensitive characters.
time-rangetime-range-name
Sequence number for the first rule in the ACL or time
range.
starting-sequence-number
Number that the device adds to each subsequent
sequence number.
increment
Command Default
None
Command Modes
Global configuration
Command History
ModificationRelease
Support for IPv6 ACLs was added.4.1(2)
This command was introduced.4.0(1)
Cisco Nexus 7000 Series Security Command Reference
621
R Commands
resequence